My KryoFlux

Show us your setup and show us where the units are being used.
Post Reply
Joe Maroni
Posts: 6
Joined: Fri Nov 12, 2010 8:08 pm

My KryoFlux

Post by Joe Maroni »

because it bothered me that the powerful KryoFlux board was not in a case i decided to create my own "KryoStation". I´ve took an old case of an external diskdrive and unscrewed every part of it...
then i put a Samsung SFD-321 (ebay for just 3,50 EUR) on the place of the original drive...then i cut off the spacers for the original board off the basic case.

after i put beside the cut-off spacers i had to drill the KryoFlux at the 4 holes that were planned to put it in a a size of 3 mm, because i had no smaller screws and 3 mm is perfect.

then i took the cutted-off spacers and drill the screws into the spacers with the KryoFlux board between them...meanwhile the hot glue was ready to be used and i located a perfect position for the board...

and now its done...with a short 32 pin cable....

next step will be a plate for usb and main power connector...

show me what you´ve done with you´re KryoFlux
Dsc00031.jpg (157.45 KiB) Viewed 3326 times
Dsc00029.jpg (100.73 KiB) Viewed 3326 times
User avatar
Posts: 3080
Joined: Mon Nov 08, 2010 2:42 pm

Re: My KryoFlux

Post by IFW »

Lovely :D
User avatar
Posts: 156
Joined: Sun Oct 31, 2010 10:57 pm
Location: Brisbane, Australia

Re: My KryoFlux

Post by Malvineous »

That's quite nice! I've been thinking about putting the KryoFlux + 5.25" floppy into an external 5.25" enclosure (like the ones you can buy cheap off eBay for external DVD writers) but the only problem is then my KryoFlux is limited to one drive, whereas I have four I will be switching between...
Post Reply