The only minor problem I encountered after the drive was reassembled and connected again to the KryoFlux was that I notice most of my old Verbatim disks slide in the floppy disk slot just fine, but with some very minor resistance about halfway in. This did not happen at all prior to the flippy modification.
One vendor diskette was slightly thicker and met total resistance about halfway in. Turned out to be one of the head shield cover screws was too long for that position. The shield cover secures with three screws, two short one long. This photo shows were the one was that was too long and interfered with the disk insertion.
Thanks to all who helped make this flippy mod possible! Imaging a double-sided 5-1/4 disk in one pass is indeed the kingway!!
Show us your setup and show us where the units are being used.
2 posts • Page 1 of 1