I'm happy to report my flippy mod was a success. I searched the forum for any picture insights for adding the by-pass circuit to this drive but only found a dead reference in the forum for a flippy mod. The YouTube vid was extremely helpful, however.
So I thought I would post how I implemented the two 1K resistors and the 2N2222 switching transistor to the Panasonic floppy controller board along with some other reference photos.
It appears there is a limit of three photos per post so this next photo will be in a following post.
Flippy Mod-Panasonic JU-475 AKJ
Flippy Mod-Panasonic JU-475 AKJ
airnocker
----------------------------------------------
Everything depends on everything else
----------------------------------------------
Everything depends on everything else