Page 1 of 1

My 3D Printed Kryoflux Case

Posted: Sun Jan 31, 2016 6:58 am
by COREi64
Received my new board the other day. Been reading through the documentation to prepare myself for it's arrival. Thrilled when it finally arrived.

Had decided that there was NO WAY I was going to operate my board without some significant protection (as a rule I don't operate bare board electronics without some level of casing/protection)... Just how I deal with ensuring I won't have any unfortunate accidents.

Anyways, this is the solution that I came up with:

Here are the renders:

Image

Image

Image

Here is the finished product:

Image

Image

After a bumpy start forcing Windows to accept the Kryoflux drivers, I'm happy to report this a unmitigated success, both in operation and in my successful casing of this great board.

Now I'm off to backing up and duplicating my personal collection of Commodore software.

Thomas
COREi64

Re: My 3D Printed Kryoflux Case

Posted: Sun Jan 31, 2016 6:42 pm
by IFW
Very nice :)

Re: My 3D Printed Kryoflux Case

Posted: Mon Feb 01, 2016 1:20 am
by rcade
I printed the one already on Thingiverse, but yours is much nicer. :)

Re: My 3D Printed Kryoflux Case

Posted: Mon Feb 01, 2016 5:43 am
by COREi64
Thanks very much.

Quite happy with how it turned out.

Thomas
COREi64