Page 18 of 24

Re: Drives confirmed working with KryoFlux

Posted: Fri Aug 15, 2014 11:50 pm
by Stanglnator
5,25" Y-E Data, YD-380B - 84 Tracks and work with Flippy Mode without modifications ;)

I was able to read both sides from a C64-Disk.

Re: Drives confirmed working with KryoFlux

Posted: Sat Aug 16, 2014 12:38 pm
by IFW
That sounds strange... did you get any *T warnings?

Re: Drives confirmed working with KryoFlux

Posted: Tue Aug 19, 2014 2:28 pm
by Stanglnator
Nope only a Message when the Drive reads Track 0 , but i think this is normal.

I read a C64-Disk with Games on both Sides and the finaly created .D64 in Vice where ok.

Re: Drives confirmed working with KryoFlux

Posted: Wed Aug 20, 2014 2:50 am
by IFW
This would be the first ever drive that does not need modding :)
As long as you don't get any *T messages from the format output (except for some protections) it should be fine.

Re: Drives confirmed working with KryoFlux

Posted: Sun Sep 28, 2014 10:34 pm
by Gringo
Read and Write Work Fine, tested only on Amiga Format (Low and High Density)
3.5' - Panasonic JU-257-524P - (0-83) 84 Tracks
3.5' - Panasonic JU-257A606P - (0-83) 84 Tracks
3.5' - Sony MPF920-E FEB2003 - (0-83) 84 Tracks
3.5' - Sony MPF920-E FEB2006 - (0-83) 84 Tracks
----
PS: After some Test, i have noticed the Panasonic JU-257A606P work better on Old Amiga Forced HD (The DD media used making an "hole" on left side),
the Sony don't like wery well this media when they have 20 year or more... :lol:

Re: Drives confirmed working with KryoFlux

Posted: Tue Dec 30, 2014 3:47 pm
by opa
Hi,

again regarding 5,25" Chinon FZ506, Rev.A (with 13 jumpers):

works for me with the following settings:
Jumperposition 13 to 1: (x=jumper set)
x..x......x..

So it means drive is DS1 and termination is off..
This config works both for single drive mode and for 2 drives on the cable.

For the list:
Tracks: 84

Re: Drives confirmed working with KryoFlux

Posted: Fri Jan 09, 2015 2:56 pm
by JanneG
"New" unmodified Y-E Data YD-380B here, and seems to be working perfectly with C64 originals. No *T warnings or anything either.

Re: Drives confirmed working with KryoFlux

Posted: Fri Jan 09, 2015 3:55 pm
by brightcaster
Just to confirm, do I understand right, that this drive reads both sides of C64 flippy-disks without modification!?

Re: Drives confirmed working with KryoFlux

Posted: Tue Jan 20, 2015 1:04 pm
by Hok of Remember
Does this also count for the YD-380 or just the YD-380B? Does anyone have an YD-380 and could check that?

Re: Drives confirmed working with KryoFlux

Posted: Mon Feb 02, 2015 1:39 pm
by Hok of Remember
Just purchased this. I'll let you know if/how it works for me regarding C64 flippy disks without modification.

JanneG or Stanglnator, does any of you guys know how to set this drive to DD-mode?