Today my Kryoflux system stopped working. I ran
as usual and it came up with the usual numbers.
I then progressed as normal.
Upon inserting the diskette however, the drive sounded really fishy. Basically it spins high, but doesn't do anything else.
I tried over and over but now the Kryoflux doesn't recognize any board anymore. Instead of getting me the number of available positions it just spins every drive I give it it high.
I tried three drives now and two computers (Win 10 and 7). I am rather confident now that my Kryoflux might be dead
Have you ever experienced something similar?
With kind regards
In that case "Remove all cables, power off the board, set the "test" jumper, power on for 10 seconds, poweroff, remove the "test" jumper, and try again. This should reset the board in case the firmware is in some way corrupted"....