Page 1 of 1

Not working with one of my computers.

Posted: Sun Jun 07, 2020 10:35 pm
by flaviosr
Dear All,
I tried to write some floppies (RAW, ADF...) in one of my computers and I receive the following error:
Senza nome.jpg
I can check the FDD and I can dump... I only cannot write! :(
In another computer everything is working... the matter could seem solved but I "need" to use my Kryoflux in a specific PC that is located in my "Laboratory".
Can somebody find out the issue?

Another issue is the BOSSA one... from time to time Windows decides to "force" the BOSSA driver instead than the Kryoflux one... is there a way to solve this issue?

Thank you

Re: Not working with one of my computers.

Posted: Mon Jun 08, 2020 4:40 pm
by ZrX
Is it the same drive that writes ok on the other computer or are they two different drives?

Re: Not working with one of my computers.

Posted: Tue Jun 09, 2020 7:08 pm
by flaviosr
ZrX wrote:
Mon Jun 08, 2020 4:40 pm
Is it the same drive that writes ok on the other computer or are they two different drives?
Completely the same HW. I have prepared a KryoBox! :)
DSC_0016.JPG
DSC_0010.JPG
I also tried with running the DOS session as an Administrator but nothing...
Is it possible to write with the shell? I do not find anything about this possibility...

Re: Not working with one of my computers.

Posted: Wed Jun 10, 2020 7:50 am
by brightcaster
Is it possible to write with the shell? I do not find anything about this possibility...
What do you mean with "shell"? Didn't you do exactly that in the first picture you posted?

David

Re: Not working with one of my computers.

Posted: Wed Jun 10, 2020 6:50 pm
by SomeGuy
The GUI shell does not include an option to write. Currently, this can only be done with the command line tool.

It is strange that it passes the calibrate test but then fails writing. Can this machine read and decode disks ok?

Make sure you have the same software versions on both computers.

Re: Not working with one of my computers.

Posted: Wed Jun 10, 2020 7:56 pm
by brightcaster
There is an other GUI tool for writing available in the download section at kryoflux.com:

http://www.kryoflux.com/download/wildewutz_0.7zip

David

Re: Not working with one of my computers.

Posted: Tue Jun 23, 2020 7:42 pm
by flaviosr
Windows issue... for some reasons Windows decided not to update the drivers by itself... I had to overwrite the old ones and now everything works as expected.