Page 1 of 1

Problem with my kryoflux

Posted: Mon Mar 02, 2020 5:07 pm
by kthefrog
Good morning, my card that is seen in windows 10 every time I try to make an acquisition is released from the usb hub and until I reset it no longer sees it.
Also, connected disk drivers no longer work.

The error is present even if I use the dtc -c2 command
I need help. Thank you

Re: Problem with my kryoflux

Posted: Mon Mar 02, 2020 6:08 pm
by brightcaster
Looks as if the over all power consumption on the USB port is to much! BTW: Don't use a hub! The Kryoflux board should be connected directly to a main USB port (as the manual reads)...

David

Re: Problem with my kryoflux

Posted: Tue Mar 03, 2020 8:49 am
by kthefrog
Thanks for the reply. The card is connected directly to the computer's USB ports. It does not go through a hub. I have tried with three computers but the problem remains.
I don't think it's bad because it's seen regularly. If I try to acquire a disc it disconnects and I have to reset it to have it reviewed by the computer.

Re: Problem with my kryoflux

Posted: Tue Mar 03, 2020 3:57 pm
by ZrX
Could there been some change in Windows making it detect the board incorrectly when the firmware is loaded on the first use?

Is it still visible as KryoFlux Disk System after issuing dtc -c2?

Re: Problem with my kryoflux

Posted: Tue Mar 03, 2020 6:30 pm
by brightcaster
What do the LEDs on the board show? Do yellow and green light up alternately or only the red one continuously ?

David

Re: Problem with my kryoflux

Posted: Tue Mar 03, 2020 9:54 pm
by kthefrog
the system sees the card as kryoflux. The led is green but If you enter the dlc -c2 command, the card disconnects from the computer and signal a timeout error. the LEDs flash green and yellow. The computer no longer sees until reset.

Re: Problem with my kryoflux

Posted: Wed Mar 04, 2020 6:49 pm
by brightcaster
It could be the old bossa driver problem again described in this thread: viewtopic.php?f=3&t=369

David

Re: Problem with my kryoflux

Posted: Tue Mar 10, 2020 11:03 am
by kthefrog
Thanks so much!!! solved just as you indicated !!! :D :D :D