Control Command rejected by the device. CM: maxtrack=0

All questions about how to use KryoFlux go here.
brightcaster
Posts: 302
Joined: Fri Nov 08, 2013 10:48 pm

Re: Control Command rejected by the device. CM: maxtrack=0

Post by brightcaster »

Did you also try it on a different computer? Otherwise I have no further idea (to be honnest)...

David
brightcaster
Posts: 302
Joined: Fri Nov 08, 2013 10:48 pm

Re: Control Command rejected by the device. CM: maxtrack=0

Post by brightcaster »

I'm a right in asuming that the drive is not spinning from the very start but beginning to spin up, when you fire the first command? And the drives LED is also off at first, but goes on with the spinning starts?

David
markgamrat
Posts: 6
Joined: Tue Sep 24, 2019 5:20 pm

Re: Control Command rejected by the device. CM: maxtrack=0

Post by markgamrat »

No, I haven't tried on another computer. The drive light is off until I insert the floppy and turn the handle - then the drive light is on and the drive spins at that point.

Thank you to everyone for their suggestions. I'm going to return the KryoFlux.
Post Reply