All general stuff about SPS, like philosophy and mission - discuss it here!
7 posts • Page 1 of 1
So i have two 5.25” floppy drives connected to one board. No matter which drive i put the jumper d0 and d1 on the only drive that works is the one on cable connector 1. The only time a drive on cable connector 0 doesnt just tick and give me a “control command by the device” is if i have the d0/d1 matching to the drive connected on cable connector 1. Then they both just run at the same time but it only gives me the maxtrack readout of the drive on cable connector 1. The one difference i found between my cable and the one in the manual is my pins 25-29 (if pin 1 is red) are flipped and the one in the manual has pins 10-16 flipped. Do i need to changed the flipped wires on my cable to match the diagram or is there something else that is the issue? I do have the jumper pins on the kryoflux board set to the outside for dual drives.
Nope. Just a standard teac fd-55gfr and a teac fd-55br. I have them in seperate external old cd writer cases i modified to use and one has the kryoflux in it. I will be doing a 3.5” floppy drive external as well that can be attached as the second drive.