KryoFlux^® Support Forums

If the board is good, attaching it in e.g. Windows will cause a "bing" and a SAMBA device or similar will show up. The Mac will also show something as a connected device in "About this Mac / System Report / USB". To search for the issue the GUI is not helpful. It's just a GUI, us...

Since the additional signal needed to turn on the bypass makes use of one of the odd (1, 3, 5, 7 etc.) cables which are usually grounded, adding another, unmodified, drive to a flippy setup will cause this operation to fail. This is also documented. Is this possible? If not, I have wasted over €500....

Thanks a lot mr.vince, the drive is a Fujitsu M2553K, I found a manual (I am attaching it here), and it seems that this model just goes 360rpm (see page 14). So do you think that if I can dump the disk with a 300rmp speed I would be able to create readable images? Just for clarification purposes: K...

I have no experience with PC Jr. and PSI files, but does the format itself support non-standard data, violations of the recording scheme? If yes, then probably the software used for conversion does not present the scheme violations in a way expected by the program.

There is a "density line" setting under the drive menu which should, while switching between HD and DD, also change the rpm. But this does not always work, it's something the drive does or does not. Some drives can be set via jumpers. KryoFlux itself can resample the data internally and in...

Could also be a lose connection or a bad cable. Have had this before.

Sorry for chiming in so late. Brightcaster is absolutely correct. The term weak just refers to the bit pattern, which changes, but the magnetic parameters are always the same. This is all about timing. The coding scheme enforces polarity changes. After all, we're looking at an AC recording scheme (m...

Please check the voltage and let us know. Unfortunately, there's not much one can do to avoid PSUs dying. I've lost monitors, AV receivers and some other gear. In most cases, it's the power supply because the switching puts a lot of stress on the components and these things get smaller and smaller. ...

We have received the board. The MOLEX connector and the are around shows some brownish residue, apparently from some type of liquid. More via email.

But since you already have included a lot of support for this in dtc already, wouldn't it be possible to share the info that the decoders in dtc is based on at least? This is not a database with wiki articles we could share. All of this is internal documentation and well commented code in DTC. The ...